Products Handle for high pressure cleaner
This hollow handle is produced with air assisted injection moulding. Better quality and reduced cost are achived compared with the traditional solution: a handle assembled from two half shells using snap locks.

This handle is part of a high pressure cleaner. The cleaner can rotate around the joint at the bottom of the handle.

The material is a blend that combines the qualities of ABS and PA.
Danish Name Håndtag til højtryksrenser
Category Outdoor equipment
Materials PA ABS
Processes Air assisted injection moulding
References KEW AS
Micotron a/s
Keywords Outdoor equipment
Hollow shape
Handle
Joint
Plastic
Photo Ole Akhøj
Copyright © 1996-2003 Torben Lenau
This page is part of Design inSite